The Story
The short answer
Yes. Cook the fries straight from frozen at 400 degrees, with the basket no more than half full, and shake the basket partway through. Thin fries take about 10 to 14 minutes, regular fries take about 14 to 18 minutes, and thick steak fries take about 18 to 24 minutes. No thawing and no extra oil are needed. Salt them the moment they come out and serve them at once.
Frozen fries might be the food the air fryer does best. The bag was made for a deep fryer or a hot oven, but fast moving hot air gives you the same crisp outside and soft inside in about half the oven time, with no pot of oil to heat and no tray to scrub.
The only trick is to match the time to the cut. A thin fry and a thick steak fry behave in very different ways in the same basket, and a crowded basket will steam any cut soft. This guide walks through the method that works for every bag, and the times for each common cut.
1. Cook them straight from frozen
Why it matters: thawed fries soften and give off water before they ever meet the heat. That water turns to steam in the basket, the surface stays damp, and the fries come out limp even at the right heat. Frozen fries were also cooked in oil once at the factory, and that firm frozen shape is what lets the outside set and crisp before the inside dries out.
What to do instead: take the fries from the freezer to the basket with no stop in between. Break apart any large clumps with your hands so each fry sits on its own, and put any fries you are not cooking back in the freezer at once. If frost or ice clings to the fries, shake the bag or pat the fries dry, since loose ice adds steam the basket does not need.
2. Use 400 degrees for most cuts
Why it matters: fries need strong heat to dry and brown the surface before the inside turns soft and mealy. Below about 375 degrees, most frozen fries sit in warm air and release moisture slowly, so they cook through without ever turning crisp or golden. Sweet potato fries are the one case for lower heat, since their sugars brown fast and can scorch at the top end.
What to do instead: cook most cuts at 400 degrees, and drop sweet potato fries to 380 degrees. Run the empty machine for 3 to 5 minutes first if your model asks for it, so the fries land in a hot basket and start to crisp at once. Check the bag as well, since many brands now print air fryer times on the pack, and those times were tested on that exact fry.
3. Leave room in the basket
Why it matters: hot air has to reach every surface to crisp it, and fries piled deep trap steam between the layers. The bottom layer cooks in that steam and stays soft, while the top layer browns, so one batch holds crisp fries and soggy fries at the same time. This is the cause behind almost every soft batch.
What to do instead: fill the basket no more than half full, and keep the fries in a loose layer where most pieces can touch the moving air. Cook a large bag in two batches rather than one tall pile. Keep the first batch warm on a tray in a low oven while the second batch cooks, and give the first batch 2 to 3 minutes back in the hot basket if it softens while it waits.
4. Shake the basket partway through
Why it matters: fries that sit still cook in the shape they landed in. The sides that face the heat brown, the sides pressed to the basket or to a neighbour stay pale and soft, and thin fries on the edges can scorch while thick fries in the middle lag behind.
What to do instead: pull the basket out at the halfway point and shake it well so the fries tumble and turn. For thick steak fries and wedges, shake once more near the end as well. Start to check a minute or two before the timer ends, pull out any fries that are already deep golden, and give the rest a short finish on their own.
5. Match the time to the cut
Why it matters: thickness sets the time more than anything else in the bag. Thin fries can pass from golden to burnt in two minutes, while the centre of a thick steak fry is still cold at the point where a thin fry is done. One time for every bag will burn the thin cuts and leave the thick cuts raw in the middle.
What to do instead: use the table below as your start point, and judge the finish by look and feel. A done fry is golden all over, crisp when you tap it, and soft when you break it open. Write down the time that worked in your machine for the bag you buy most, since each model runs a bit hot or a bit cool and your own note beats any chart after the first cook.
6. Salt at once and serve at once
Why it matters: fries lose their crisp edge fast as they sit. Steam from the hot inside keeps moving to the surface, and a pile of fries on a cold plate or in a closed box traps that steam and softens the whole batch in minutes. Salt also slides off a fry that has cooled and dried. For fries with more than salt on them, my spicy seasoned fries are the ones I make at home.
What to do instead: tip the fries onto a wide plate or a rack in a loose layer, salt them while the surface is still hot and a bit glossy, and serve them within a few minutes. They go well beside frozen burgers in the air fryer on a busy night. If a batch does soften, spread it in the basket in a loose layer and give it 3 to 4 minutes at 400 degrees, and it will crisp again. Leftovers keep in the fridge for up to 3 days and come back the same way.
Quick reference
| Fry cut | Heat | Time |
|---|---|---|
| Thin and shoestring fries | 400 degrees | 10 to 14 minutes |
| Regular straight cut fries | 400 degrees | 14 to 18 minutes |
| Crinkle cut fries | 400 degrees | 14 to 18 minutes |
| Waffle fries | 400 degrees | 12 to 16 minutes |
| Steak fries and wedges | 400 degrees | 18 to 24 minutes |
| Sweet potato fries | 380 degrees | 14 to 18 minutes |
Can you cook frozen french fries in an air fryer? Yes, and it is the best way most home cooks have to make them. Keep them frozen, keep the basket no more than half full, cook at 400 degrees with a good shake partway through, and match the time to the cut. Do that and the fries come out crisp, golden, and ready the moment the basket opens.